Aritech ADVISOR CD 7203 Instrukcja Użytkownika Pobierz pdf (Strona 86)

Page 86 Manager Manual for CD72/95/15003

warning time begins from the start, with the exception that arming can no longer be postponed (dependent on

the options).

When the delay is activated, a message can be sent to the central station (automatic arming delayed and

arming at hh:mm).

Delay the arming time

If the arming time is delayed, the warning time will begin again at the end of the delay period. This indicates

that automatic arming or arming monitoring will be started. It depends on how your installer has programmed

the system whether you can delay automatic arming or arming monitoring again. When the warning time has

expired, the exit time begins. If the system is disturbed or there is an exit fault, the system will not be armed.

A message can be sent to the central station (armed late or exit fault).

Special options

There are some special options when using timeslots. These options are:

1. Forced arming can be used. If the system is disturbed during arming, it will not be armed. Using a

forced arm, zones which are disturbed are automatically inhibited. The only exceptions are zones

which are delayed during the entry or exit time or zones which cannot be inhibited. However, as

forced arming results in an uncontrollable system, this option is not usually used.

2. The installer can activate a special option (action list) with which automatic arming is disarmed for

one period. As a user, you must enter a special code during the day to use this. If you want to arm

the system, you can do so using your own user code. The next disarm will be performed by the

timer as usual. No separate message about this can be sent to the central station.

3. Depending on your wishes, you can change holiday periods yourself, activate the delay several

times and activate the delay during the day. Finally, you can have the option of indicating during the

day that the system must not arm automatically that day. You then have to arm the system yourself.

Automatic disarming will, however, take place.

These options depend on the security level and the attributes assigned to your code. The table below shows

the options:

Option Maximum security Low security

only Ax - Only delay automatic arming during the

warning period

- Always delay automatic arming during

the warning period

- Delay automatic arming to a time to be

specified (postpone)

- Next automatic arming cancelled

Ax and Mg - Enter a holiday period during the day - Enter a holiday period during the day

Technical Manuals Online! - http://www.tech-man.com

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 107 108

Brak uwag

Aritech ADVISOR CD 7203 Instrukcja Użytkownika Strona 86